Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
72:configure_jaas_jgss [2019/10/17 10:48] – twn | 72:configure_jaas_jgss [2019/11/15 13:05] – [Configure JAAS and JGSS Support on the Stages Server] etea | ||
---|---|---|---|
Line 10: | Line 10: | ||
de.methodpark.pkit.auth.SpnegoAuthenticator { | de.methodpark.pkit.auth.SpnegoAuthenticator { | ||
com.sun.security.auth.module.Krb5LoginModule required | com.sun.security.auth.module.Krb5LoginModule required | ||
- | useKeyTab="true" | + | useKeyTab=true |
keyTab="// | keyTab="// | ||
- | storeKey="true" | + | storeKey=true |
realm="< | realm="< | ||
debug=" | debug=" | ||
Line 34: | Line 34: | ||
| | ||
| | ||
- | | + | |
- | } | + | }; |
</ | </ | ||
Line 83: | Line 83: | ||
To test your JAAS and JGSS configuration in a Stages server environment proceed in the way described below: | To test your JAAS and JGSS configuration in a Stages server environment proceed in the way described below: | ||
- | * Open a command prompt and change to the <PKIT_HOME> directory. | + | * Open a command prompt and change to the <stages> directory. |
* Type ''< | * Type ''< | ||
* Watch the command prompt for output messages. | * Watch the command prompt for output messages. |