Stages Documentation

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
72:general_configuration [2018/09/27 18:06] – [General Configuration of Stages] emr72:general_configuration [2019/09/20 07:07] – [General Configuration of Stages] sph
Line 5: Line 5:
 === Configuration File === === Configuration File ===
  
-Stages can be configured in the <StagesInstallDir>/tomcat/webapps/pkit/WEB-INF/conf/ PKitConfig.xml configuration file. In its properties section some parameters can be configured by introducing name-value pairs. For information about existing configuration parameters and their effect please contact the Stages support.+Stages can be configured in the ''<StagesInstallDir>/conf/config.xml'' configuration file. In its properties section some parameters can be configured by introducing name-value pairs. For information about existing configuration parameters and their effect please contact the Stages support.
  
 The following code configures a value of “value.of.property” for the configuration property “name.of.property”: The following code configures a value of “value.of.property” for the configuration property “name.of.property”:
Line 17: Line 17:
 === Configuration of Stages Service Parameter === === Configuration of Stages Service Parameter ===
  
-Stages service can be configured in the tomcat service configuration GUI<StagesInstallDir>\tomcat \bin\tomcatw.exe. To start the tomcat GUIplease run the following command in MS-DOS shell: +Stages service can be configured in the tomcat service configuration GUI ''<StagesInstallDir>\tomcat \bin\tomcatw.exe''. To start the tomcat GUI please run the following command in MS-DOS shell: 
- +<code> 
-''bin/tomcatw.exe //ES//projectkit''+bin\tomcatw.exe //ES//stages 
 +</code>
  
 In the Java tab you can configure additional Java start parameter for Stages that are listed below: In the Java tab you can configure additional Java start parameter for Stages that are listed below:
  
-  * Xmx (Max memory pool): 1024 MB +  * Xmx (Max memory pool): 4048 MB 
-  * Xms (Initial memory pool): 512 MB +  * Xms (Initial memory pool): 4048 MB 
-  * Remote monitoring of Stages application via JConsole or SVisualVM +  * Remote monitoring of Stages application via JConsole or JVisualVM 
-      * ​​​Dcom.sun.management.jmxremote.port=8055 +  * ​​​Dcom.sun.management.jmxremote.port=8055 
-      * Dcom.sun.management.jmxremote.authenticate=false +  * Dcom.sun.management.jmxremote.authenticate=false 
-      * Dcom.sun.management.jmxremote.ssl=false +  * Dcom.sun.management.jmxremote.ssl=false
-  * Set Option for not garbage collected Java heap size, the so called permanent generation: +
-      * XX:MaxPermSize=256m +
-      * XX:PermSize=256m+