Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
72:ldap_url_attribute [2018/07/16 12:42] – [URL Attribute] bkkr | 72:ldap_url_attribute [2024/02/15 00:00] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 5: | Line 5: | ||
The url attribute is used to set the LDAP URL of the server to be queried. The attribute is structured in the following way: | The url attribute is used to set the LDAP URL of the server to be queried. The attribute is structured in the following way: | ||
- | <font inherit/ | + | '' |
The following table describes how to fill this schema with concrete values: | The following table describes how to fill this schema with concrete values: | ||
+ | |||
+ | ^Schema Values^Description| | ||
+ | |ldap|The LDAP URL starts with a protocol prefix which is normally set to “ldap“. If you want to encrypt the synchronization process via SSL, use " | ||
+ | |ldap-server|The fully qualified domain name of the LDAP server| | ||
+ | |port|The TCP port the LDAP server is listening on. The standard TCP port for unencrypted LDAP communication is 389, whereas 636 is used for secure communication.| | ||
+ | |ldap_directory_to_be_queried|The distinguished name of the directory to be queried, including the server’s base dn.| | ||
+ | |||
+ | A sample url attribute setting is given as follows: | ||
+ | |||
+ | '' | ||
+ | |||
+ | As mentioned above, configuring LDAP is a very customer specific task. Therefore the value of the url attribute can differ quite strongly from the example given above. | ||
+ | |||
+ | \\ | ||