Stages Documentation

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
75:install [2020/06/25 18:07] – emr75:install [2020/07/17 15:59] – emr
Line 195: Line 195:
  
   * Ask for a DNS alias for the server, e.g. "stages.company.com"   * Ask for a DNS alias for the server, e.g. "stages.company.com"
-  * Ask for a SSL certificate for the server which refers to the above alias. Depending on your local procedures, this might require creating a certificate request (see [[https://www.digicert.com/csr-ssl-installation/tomcat-keytool.htm|https://www.digicert.com/csr-ssl-installation/tomcat-keytool.htm]] for more info).+  * Ask for a SSL certificate for the server which refers to the above alias. Depending on your local procedures, this might require creating a certificate request (see [[https://www.digicert.com/csr-ssl-installation/tomcat-keytool.htm|https://www.digicert.com/csr-ssl-installation/tomcat-keytool.htm]] for more info). If you are seeing "Invalid Certificate" errors in Chrome or Edge, add the "-ext SAN=dns:stages.yourcompany.com" argument to the keytool command and replace stages.yourcompany.com with the offical alias you use for accessing Stages.
   * Import the SSL certificate into a keystore (see link above for more info)   * Import the SSL certificate into a keystore (see link above for more info)
   * Configure Tomcat to use this SSL certificate (see link above for more info). The relevant Tomcat config file is located in ''conf/server.xml''  and the SSL info needs to be configured for each ''<Connector>''  section. After updating the config file, run ''bin/update.sh''  or ''bin\update.bat''  to install it at the correct location.   * Configure Tomcat to use this SSL certificate (see link above for more info). The relevant Tomcat config file is located in ''conf/server.xml''  and the SSL info needs to be configured for each ''<Connector>''  section. After updating the config file, run ''bin/update.sh''  or ''bin\update.bat''  to install it at the correct location.