Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
75:install [2020/06/25 18:07]
Erich Meier
75:install [2020/07/17 15:59] (current)
Erich Meier
Line 195: Line 195:
  
   * Ask for a DNS alias for the server, e.g. "​stages.company.com"​   * Ask for a DNS alias for the server, e.g. "​stages.company.com"​
-  * Ask for a SSL certificate for the server which refers to the above alias. Depending on your local procedures, this might require creating a certificate request (see [[https://​www.digicert.com/​csr-ssl-installation/​tomcat-keytool.htm|https://​www.digicert.com/​csr-ssl-installation/​tomcat-keytool.htm]] for more info).+  * Ask for a SSL certificate for the server which refers to the above alias. Depending on your local procedures, this might require creating a certificate request (see [[https://​www.digicert.com/​csr-ssl-installation/​tomcat-keytool.htm|https://​www.digicert.com/​csr-ssl-installation/​tomcat-keytool.htm]] for more info). If you are seeing "​Invalid Certificate"​ errors in Chrome or Edge, add the "-ext SAN=dns:​stages.yourcompany.com"​ argument to the keytool command and replace stages.yourcompany.com with the offical alias you use for accessing Stages.
   * Import the SSL certificate into a keystore (see link above for more info)   * Import the SSL certificate into a keystore (see link above for more info)
   * Configure Tomcat to use this SSL certificate (see link above for more info). The relevant Tomcat config file is located in ''​conf/​server.xml'' ​ and the SSL info needs to be configured for each ''<​Connector>'' ​ section. After updating the config file, run ''​bin/​update.sh'' ​ or ''​bin\update.bat'' ​ to install it at the correct location.   * Configure Tomcat to use this SSL certificate (see link above for more info). The relevant Tomcat config file is located in ''​conf/​server.xml'' ​ and the SSL info needs to be configured for each ''<​Connector>'' ​ section. After updating the config file, run ''​bin/​update.sh'' ​ or ''​bin\update.bat'' ​ to install it at the correct location.