Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision |
72:general_configuration [2018/09/27 18:11] – emr | 72:general_configuration [2019/09/20 07:01] – [General Configuration of Stages] sph |
---|
Stages service can be configured in the tomcat service configuration GUI ''<StagesInstallDir>\tomcat \bin\tomcatw.exe''. To start the tomcat GUI please run the following command in MS-DOS shell: | Stages service can be configured in the tomcat service configuration GUI ''<StagesInstallDir>\tomcat \bin\tomcatw.exe''. To start the tomcat GUI please run the following command in MS-DOS shell: |
| |
''bin/tomcatw.exe //ES//stages'' | ''bin\tomcatw.exe '//ES'////stages//'' |
| |
In the Java tab you can configure additional Java start parameter for Stages that are listed below: | ''//In the Java tab you can configure additional Java start parameter for Stages that are listed below: * Xmx (Max memory pool): 4048 MB * Xms (Initial memory pool): 4048 MB * Remote monitoring of Stages application via JConsole or JVisualVM * Dcom.sun.management.jmxremote.port=8055 * Dcom.sun.management.jmxremote.authenticate=false * Dcom.sun.management.jmxremote.ssl=false //'' |
| |
* Xmx (Max memory pool): 4048 MB | |
* Xms (Initial memory pool): 4048 MB | |
* Remote monitoring of Stages application via JConsole or JVisualVM | |
* Dcom.sun.management.jmxremote.port=8055 | |
* Dcom.sun.management.jmxremote.authenticate=false | |
* Dcom.sun.management.jmxremote.ssl=false | |
| |
| |